The Seagate SkyHawk AI 10TB ST10000VE0004 is a 10TB SATA-6G enterprise drive at $48.50/TB - Verify recording technology before use in RAID. New unit with full 5-year warranty.
Against every other drive we have an in-stock price for today, this one is cheaper per tb than 27% of them (64 of 237). The cheapest we can currently buy is $14.99/TB; the middle of the market is $39.13/TB.
These are third-party figures about the retail market as a whole, quoted and dated. They are not our own measurements and they do not describe this specific drive.
Resolved against manufacturer compatibility lists we read and dated, capped at 4. Vendor-listed means the manufacturer names this exact part number; fit-verified is our own check of form factor, interface and recording technology against a published requirement. Neither is a guess, and a drive the registry cannot resolve shows nothing here rather than a maybe. How compatibility actually works
Yes. At our last check it was $485.00 ($48.50 per terabyte at its 10TB capacity), sold new under ASIN B0776SG16F. Amazon sets the final price at checkout.
This listing (ST10000VE0004, ASIN B0776SG16F) carries no renewed, recertified, refurbished or pulled claim in its title, and Amazon reports it as new. On this site that is what "new" means: sold as factory-new. The stored warranty on this row is 5 years, as the listing states it.
Use Case Scenarios
🏠
Home & SMB NAS
Building a mid-range NAS for media, backups and file sharing.
✓ Excellent fit
Verify CMR recording before using in RAID. New drives come with full warranty.
💾
Backup Server / Veeam Target
Dedicated backup storage for Veeam, Commvault, or NetBackup.
✓ Excellent fit
10TB SATA drives are ideal for backup targets. SATA gives maximum $/TB for backup repositories.
🏗️
Virtualization Host Storage
VM images and snapshots on Proxmox, VMware or Hyper-V.
~ Good fit
Suitable for VM storage where workloads are not IOPS-intensive. SATA is fine for single-host VM storage. Consider NVMe cache for latency-sensitive VMs.
Maintenance & Troubleshooting
Maintenance Checklist
On installCheck SMART baseline on arrival
Run smartctl -a /dev/sdX and record: Reallocated_Sector_Ct, Power_On_Hours, Spin_Retry_Count. Establishes baseline for future comparison.
MonthlyRun SMART short self-test
smartctl -t short /dev/sdX — takes 1-2 minutes, catches most developing issues. Schedule during off-peak.
QuarterlyRun SMART long self-test
smartctl -t long /dev/sdX — full surface scan, takes 5 hours for 10TB. Any test failure is grounds for immediate replacement.
QuarterlyCheck RAID array health
Verify no degraded drives. A degraded array with no hot spare is one failure from data loss. Check mdstat or controller UI.
AnnuallyVerify drive firmware version
Check Seagate support site for firmware updates. Some versions have known bugs affecting integrity.
Every 3-5 yearsPlan proactive replacement
Enterprise HDDs have higher failure rates after year 4-5. At 10TB per drive, budget for replacements before failures occur.
Troubleshooting Guide
Cause: Loose SATA data or power cable, failed port, or drive not spinning up.
Fix: Reseat both cables. Try a different port. Listen for spin-up sound. Test with a known-good cable.